Bite Tester
toys testing instruments
Application
It is used to test whether the toys has cracked after bite test, and if it has produced hazardous sharp points, hazardous sharp edges, and hazardous small parts after crack.
Test Method
The test article shall be placed in the contact mechanism in any reasonable position for a penetration of 0.25 to 0.5 inch (0.64 to 1.27 centimeters), which position utilizes less than 180 degrees of the arc of the contact mechanism, and a test load shall be evenly applied within 5 seconds. This load shall be maintained for an additional 10 seconds.
Key Specification
ModelGT-M45MaterialStainless steelDimensions89 x 42 x 47 mmPacking dimension150 x 105 x 70 mmWeight1kg Standards16 CFR 1500 section 51 and 52 and 53Optional accessoriesIMADA FB-200N Push-Pull Scale
GT-MB01 Sharp Edge Tester
GT-MB04 Sharp Point Tester
GT-MB03 Small Part Cylinder
GT-M33 Push-Pull Test Stand